Life Probo Pr70 Instructions For Installation Use And Maintenance Manual 10 Pages Upd ((top)) -

Insert the motor’s protruding shaft (8) into the block (9) on the runner, ensuring proper alignment without forcing the tab.

In the event of a prolonged residential power failure or an internal electrical malfunction, you can disengage the motor to operate the door by hand. Insert the motor’s protruding shaft (8) into the

Insert the drive sprocket shaft located on the motor head into the designated drive socket at the rear of the rail assembly. : Separate 230V cables from low-voltage ones

: Separate 230V cables from low-voltage ones. Insert them through specific holes in the base and secure with a cable gland. Initial Setup : Switch on the power; two red LEDs should flash. Radio Control : Press the Radio Control : Press the Use the provided

Use the provided power cable with the ready-wired Schuko plug; do not shorten or extend this cable. Initial Setup

Once you've installed your Life Pro Bo PR70, it's time to start using it. Here are the steps to follow: